PROSPOTfitness Fusion SSG, Руководство пользователя

Страница: 6 / 22

STEP #5 –
SSG
ACCESSORIES & MISC.
1. Now according to diagram #4, install (#129) Plastic Spacing Sleeve & (#62) Foam Roller
onto (#85) Lat Leg Hold Down tubes. At this time place accessory into position on Bench
and lock with (#84) Locking Pin. If (#84) Locking Pin does not slide through easily, loosen
bolts on (#82 & #83) Bench Swivel Plates, slide pin through and then tighten securely. Now
remove Lat Leg Hold Down and store in one of the (#34) Accessory holders according to
diagram.
2. Now according to diagram #1, #2 & #3 prepare to install (#23) & (#43) Locking Post Covers.
First connect Neon light wire harness into ( #162) & (163) Wire Harness’s. Next using (115)
Screws and (#101 washers) attach (#23) & (#43) Locking Post Covers on their proper sides
according to diagram #1, #2 & #3.
3. Add (#45) Clip to (#48) Low Row Bar and attach (#49) Chain. Now place in holder located
on left Locking Post Cover.
4. Place (#44) Lat Bar in holder located on right Locking Post Cover.
5. Add (#45) Clip to (#47) Lat Cable.
6. Add (#45) Clip to (#137) Low Row Cable and connect (#133) Bench Cable.
7. Now according to the diagram #4, install (#129) Plastic Spacing Sleeves & (#62) Foam
Rollers onto (#63) Roller Support Tube of Leg Developer. Now store in one of the (#34)
Accessory holders according to diagram.
8. Now test folding function of unit for proper clearance of stored accessories in holders. If they
interfere, try reversing front to back.
STEP #6 – WALL BRACKET INSTALATION
DO NOT OMIT THIS STEP OF THE INSTALLATION –IMPORTANT TO
SAFETY OF THE USER. TIPPING IS POSSIBLE IF NOT SECURED
PROPERLY.
1. Place unit against wall in desired position. Find nearest wall stud at rear of (#42) Lat Boom.
Place (#13) Wall bracket left or right side of Lat Boom so that of the small predrilled holes line up
with the stud in wall. Now mount (#13) Wall Bracket to the closest bolt hole on bracket using the
rear pulley bolt of the (#42) Lat Boom and tighten securely. See diagram #1. Now fasten the
Wall Bracket to the wall using screw (#102) #12 x 1-1/2” into stud. Test for strength.
Page 6