Prophete INDEX-14, Руководство по эксплуатации, Страница: 150 / 444

58 EN
WHEELS • BOTTOM BRACKET CRANK
INSTALLING THE FRONT WHEEL
1. Insert the front wheel straight into the axle holder with the motor
cable on the right (only for models with front-wheel motor).
2. Push the washers and nuts onto the axle.
3. Tighten the axle nuts again with a 18 mm or 15 mm wrench (see
chapter on torque specification).
4. Place both caps onto the axle nuts.
5. Only for models with front hub motor: Plug the motor cable
176
into the socket
177
.
6. V-brake rim brake: Connect the brake cable
171
again.
Hydraulic rim brake: Push the brake cylinder
174
back onto the
cantilever socket
173
.
7. Hydraulic rim brake: Close the quick-clamping lever
175
[CLOSE]. If
the lever closes too easily, the quick-clamping screw must be ad-
justed (see chapter Brakes).
8. Check that the rim brake works properly. Adjust it if necessary (s.
chapter Brake).
REAR WHEEL
The procedure for removing and installing the rear wheel depends on the
gearshift system installed (see chapter Gearshift).
BOTTOM BRACKET CRANK
TIGHTENING THE BOTTOM BRACKET CRANK
1. If present, remove the cover cap on both sides
178
, e.g. with
a screwdriver.
2. Tighten the screw
179
low depending on model, with an 8
mm hexagon socket wrench or a special socket acc. to the
torque specification (s. chapter Torque specifications).
3. Push on the covering cap
178
again.
173
174
175
DANGER OF DAMAGE AND ACCIDENTS!
• Regularly check that the screw connection of the foot pedal is tight. The pe­
dal arms may otherwise come loose and the foot pedal, including the inner
bearing, may be damaged.
WARNING!
179
178
176
177