Ultra Electronics Ltd
Pronto Maintenance Manual
- 81 -
06:04
This error is raised while measuring the positions of the resin calibration marks during image position
calibration if we fail to see a light-to-dark bar transition at the mid Sensor within 10 seconds. Note
that we have already detected the edge of the Card by this point.
06:05
This error is raised while trying to feed a Card from the Hopper if the mid Sensor remains clear for
more than 6 seconds. Note that by this point the rear Sensor has already been obscured (hopefully
by a Card).
06:06
This error is raised while trying to return the Card to the standby position (over the mid Sensor) from
over the rear Sensor if we fail to see the rear Sensor unblock within 3 seconds.
06:07
This error is raised while trying to hand-feed a Card to the standby position (over the mid Sensor) if
we fail to see the mid Sensor block within 5 seconds. Note that by this point we have already seen
the front Sensor block and then unblock.
06:08
This error is raised while trying to move a Card from the smart encoding position to the standby
position (over the mid Sensor) if we fail to see the mid Sensor block within 5 seconds.
06:09
This error is raised while trying to move the Card from over the front Sensor to the standby position
(over the mid Sensor) if the front Sensor does not unblock within 3 seconds.
06:10
This error is raised while trying to move the Card from over the front Sensor to the standby position
(over the mid Sensor) if the mid Sensor does not block within 3 seconds. Note that by this point we
have already seen the front Sensor unblock.
06:11
Not applicable to the PRONTO.
06:12
Not applicable to the PRONTO.
06:13
This error is raised while trying to move the Card into the magnetic encoding standby position (which
is where rear edge of the Card just blocks the rear Sensor) if the rear Sensor does not block within 4
seconds.
06:14
This error is raised during magnetic encoding if we fail to unblock the rear Sensor within 4 seconds.
By this point we have already successfully placed the Card into the magnetic encoding standby
position (where the rear edge of the Card just blocks the rear Sensor) and have begun to move the
Cards forwards towards the mag head.
06:15
This error is raised while moving the Card forwards towards the front Sensor during the soak test
routine if we fail to see the front Sensor block within 6 seconds.
06:16
This error is raised while moving the Card backwards towards the rear Sensor during the soak test
routine if we fail to see the rear Sensor block within 6 seconds.
06:17
This error is raised while moving the Card towards the Flipper ready for rotation if the front Sensor
does not block within 5 seconds.
