PRONAR T743, Руководство оператора

Страница: 137 / 150

Pronar T743 SECTION 5
5.38
•
Before starting remove all workshop aids and mount safety guards.
5.5.3 TIGHTENING TORQUE FOR NUT AND BOLT CONNECTIONS
TABLE 5.7 TIGHTENING TORQUE FOR CLUTCH BOLT CONNECTIONS
(1)
R
E
S
IS
T
A
N
C
E
C
A
T
E
G
O
R
Y
M6 M8 M10 M12 (M14) M16 (M18) M20 (M22) M24
8.8 11.3 27.3 54 93 148 230 329 464 634 798
10.9 16.5 40.1 79 137 218 338 415 661 904 1 136
(1)
– clutch Manufacturer requirements
5.5.4
SERVICE INSPECTION PERIODS
Clutch service inspection periods arising from clutch application conditions. Users should
check normal working condition and inspect clutch in the event of the occurrence of other
noises during operation. Check silent running of roller bearings. Damaged bearings should
be replaced. During inspections pay particular attention to the hydraulic oil leaks. In the event
of defect notify service point in order to perform repair.
Repair of clutch during guarantee period may only be performed by service points authorised
by the Manufacturer.
5.6 THOROUGH LOAD TANK CLEANING
Change of grain type requires thorough cleaning of trailer container to remove remains of
previous load. The chute slide, inspection covers and conveyor covers are used for this
purpose, which should be opened before beginning work. Compressed air is recommended
for thorough cleaning of tank. If it is not possible to clean tank in this way then apply a stream
of running water. Before loading trailer, it must be dried otherwise channel and conveyor may
be blocked.