PRONAR PRONAR PDT260, Руководство оператора

Страница: 79 / 97

SECTION 5 Pronar PDT260; PDT260C, PDT300; PDT 300C, PDT340
5.7
Correct oil level (A) with cutter bar in horizontal position is 4 ÷ 5mm from the cutter bar
bottom. To check oil level remove inlet cap (1) located between the third and fourth disk -
figure (5.4). When oil is cold wait approximately 15 minutes before checking the oil level. Just
check the oil level on a level cutter bar.
Check oil level in cutter bar each time before beginning work.
First oil change should be made after 50 hours mower operation and then, after each 500
hours of operation or at least once in the season, whichever occurs first. Cutter bar is filled
with SAE90EP (80W90GL5) gear oil. It is best to change oil immediately after completing
work when cutter bar is still hot and impurities are suspended in oil.
TABLE 5.2 Oil quantity
Mower model PDT260 PDT300 PDT340
Oil quantity [l] 1.75 2.1 2.4
In order to change oil in cutter bar:
•
unscrew filler plug (1) – figure (5.4),
•
raise cutterbar,
•
unscrew drain plug (2) and drain oil to previously prepared basin,
•
tighten drain plug (2),
•
Position cutting unit horizontally and pour the required quantity of oil through the
inlet (1),
Oil in cutter bar must be changed after the first 50 hours of work. The next oil change
should be made after 500 hours of work or once a year, whichever occurs first.
If a leak is noticed, carefully inspect seals and check oil level. Mower operation with low oil
level in cutter bar may cause lasting damage. Repairs of cutter bar during warranty period
(except knife replacement) may only be performed at authorised mechanical workshops.