PRONAR PRONAR PDT260, Руководство оператора

Страница: 65 / 97

SECTION 4 Pronar PDT260; PDT260C, PDT300; PDT 300C, PDT340
4.21
TIP
After removing all the spacer rings (7) disc II will operate at the height of the lower edge of
the cutter bar.
•
loosen adjustment bolts (9) counter nut,
•
by screwing or unscrewing the bolt (9) set the correct operating height of disc II
(4)
•
tighten the counter nut while being careful not to change the position of
adjustment bolt (9).
DANGER
After completing the adjustments make sure all bolt connections are tight and the range
of swath guides motion is correct. The mower may only be started when all guards are in
place.
When adjusting swath guides exercise caution as there is a risk of crushing fingers with
spring tensioned mechanisms.
4.5.6 SET THE SWATH WIDTH OF PDT260C AND PDT300C MOWER.
Two swath guides installed on the conditioner unit support frame are used to adjust the swath
width.
TABLE 4.3 The swath width for mowers with swath conditioner
Mower model PDT260C PDT300C
Swath width [mm] 1 300 / 1 900 1 700 / 2 350
The swath width can be infinitely varied in the ranges shown in the table (4.3) by adjusting
the two swath guides (1). To adjust swath guide position:
•
loosen the adjusting screw (3) in the kidney slot of the bracket (4) at the swath
guide (1),
•
rotate swath guide (1) setting the appropriate swath width, and tighten the
adjusting bolt (3) in the kidney slot,