ProMed 5040 SX, Инструкция

Страница: 22 / 124

i
nforMation on tHe unit
/
acceSSorieS
Before operating the unit for the first time, please check
that all contents have been delivered by checking whether
the line voltage required for the unit (you can find this
information on the specification plate) corresponds to
the local power supply (operating voltage of 230 V~
connected to a correctly installed wall socket with a supply
voltage of 230 V~; operating voltage of 115 V~ connected to a
correctly installed wall socket with a supply voltage of 115 V~).
• Be careful when positioned on ground level and make sure
that the ventilation slots on the rear panel are not obstructed.
Also there should be sufficient distance at the back to allow
sufficient air circulation. The environment should be dry and
at normal temperature (do not place near to the heat sources
or steam jets).
• The device must be placed in such a way that it is not above
the work height, since otherwise water will escape from the
nozzle when idle.
• The device Promed 5040SX is suitable with the appropriate
abrasive which is ideal for manicure and pedicure, especially
for medical / cosmetic foot and nail care.
• The Promed 5040SX unit uses a high performance motor.
The electronic speed control is used to smoothly set the
speed of the grinding head. The unit can rotate clockwise or
counterclockwise (switchable).
• The grinding head holder is able to fixate all commercial
grinding heads with standardized dental size shafts of 2.332
to 2.350 mm (0.091 - 0.093 inches). Please use only high-
quality grinding heads with a rounded shaft end and a
maximal shaft length of 36 mm to guarantee the longest life
possible for the grinding head holder! Always make sure that
the grinding head does not come in contact with other objects
when you lay the handpiece down. There is a risk of the shaft
becoming compressed and asymmetrical. Asymmetry in the
grinding head causes damage to the handpiece!
• Grinding head bits are available at your local specialist
retailer or Promed (www.promed.de).
• To ensure hygienic operation, the grinding heads must be
disinfected after use.
• The handpiece may only be disinfected using disinfectant
wipes.
Information about suitable disinfectants and products can be
obtained from
Promed (e.g. for abrasives Promed PURE-ID
(Art. 330810) and for the wipe disinfection Promed PURE FD
(Art. 330815)).
DE
EN
FR
IT
ES
PT
PL