o
PeratinG
tHe
unit
A.
Check the device before you bring the same into operation,
whether the voltage indicated on the device matches with the
local mains voltage. Then plug the power cord
(Q)
into the so-
cket.
B.
Attach the handpiece holder
(R)
on the device, you can do this
either on the left or on the right side.
C.
Remove the handpiece
(T)
from the protective foil and put it in
the holder provided on the device side
(R).
Please note:
If you place the handpiece next to or below the power unit
when the device is idle, a little bit of liquid will always leak
from the nozzle.
D. Filling the spray tank
• Remove the spray container
(L)
, by holding it from both the
sides and carefully pull out from the case.
• Rotate the screw
(K)
and fill the spray container
(L)
up to ap-
prox. 1-2 cm below the rim with distilled water. Rotate the
screw
(K)
again and keep the filled container back in the case
till it is locked. Ensure here that the couplings
(M)
are fixed in
each other.
• To work as fast as possible with an optimal spray function, let
the device run for approx. 4 minutes with the following settings
for constant spraying:
- Insert a cutter, polisher etc. (see „power supply/
switching and instrument change“)
- Low speed level: 2000 - 8.000 rpm (see „speed setting“)
- Spray intensity of 100 % in active mode (see „spray setting“)
This approach should be carried out after each filling of the
spray container. It takes about approx. 90 seconds till the first
time water comes out from the nozzle.
• Always use distilled water or a special mixture of distilled wa-
ter and maximum 30 % alcohol. Ordinary tap water possibly
contains calcium and other soluble substances that could cause
damage to the water tank, pumps, hoses and seals.
• In any case never fill the warm or hot liquids in the spray contai-
ner!
• Do not overfill the water tank
DE
EN
FR
IT
ES
PT
PL
Содержание 5040 SX
Страница 3: ...P M K L U T V S N R O A C E F B D J G I H Q W ...
Страница 122: ...Notizen Notes ...
