Promation Engineering P1.A Series, Руководство по установке и эксплуатации

Страница: 15 / 18

Potentiometer Pass
Potentiometer Fail
1. Loosen
potentiometer
drive gear
(2.5mm hex)
2. Adjust
gear slowly
until Blue
LED stops
BLINKING
3. Tighten potentiometer drive gear
(2.5mm hex)
4. Set DIP 5 to Off and repeat
potentiometer calibration routine
Is the Blue LED
ON steady?
Is the Blue
LED blinking 5
times?
NO
YES
YES
NO
Cycle DIP 1 OFF
then back ON to
Calibrate Feedback
2. The CW End of Travel switch
opens and motor stops
3. The Green LED goes on and
motor drives to Fully CCW
4. The CCW End of Travel switch
opens and motor stops
5. Red LED goes on and actuator
drives to Fully CLOSED
6. The controller performs an internal
Calibration of the Feedback
Blinking
Blinking
DIAG
DIAG
DIAG
DIAG
Steady
Actuator will start the
Feedback calibration
routine:
Actuator continues
Feedback calibration
routine:
1. Red LED goes on and motor drives
actuator to fully CW
Reset Cams per
instructions on pages 6-8.
Cam Settings must be
inspected. Actuator travel
must be 90° or less.Cam
setting changes have
likely made the adjusted
travel >90°.
FM14_P1A
L
V VN4 V
er J 101614
Page 13 of 14 P1.A LV AdVanced Proportional Series