2
This device complies with Part 15 of the FCC .
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
1. General Information
1-A. Model Classification:
WEC 200 - 00
○
1
○
2
○
3
○
1
Model name: WEC (Wiegand Ethernet Controller)
○
2
Model number: 200
○
3
Type: 00
standard
1-B. Accessories
a. WAS-1499 for LAN cable.
b. 5 Pin Wiegand Input (CN2-L35005-T01-G)
c. 10 Pin Output (CN2-L35010-T01-G)
1-C. Key features
Network-enable Wiegand Reader device
The beep mode of BUZZER is adjustable.
Two relay outputs are set, each relay includes Action (N.O.)/Non Action (N.C.)/Common Contact
Two input contacts are set.
Able to output Wiegand (raw data), or Facility Code (Site Code) and Card Code directly.
If your computer is equipped with one RJ45 port, you are able to connect the 10/100BaseT
Ethernet, and support TCP/IP, UDP with your Wiegand reader through WEC200.
Featuring of unduplicated service code
Able to define the machine ID and name from users
’ end.
2. Introduction
Points to follow to ensure correct use of the controller
WEC200 applies Ethernet technology to do the communication, which is important respectably
when working on the program applying Ethernet technology. Thanks to WEC200 converter, which is
built-in Ethernet module featuring:
i.
The working Ethernet package will transform all Data into Serial Signal.
ii.
The Data will be sent to MCU, the internal of WEC200.
Please refer to
Chapter 5
for framework and useful tips of WEC200
Please refer to
Chapter 6
for the functions of MCU
The package tool named
“
DS manage
r
” and “
Connection wizard
” should be attached, which
both equip you rapidly to set a virtual COM port. With connecting to WEC200, you may run the