Promac 214AB-M, Руководство пользователя

Страница: 4 / 35

4
Always wear safety glasses!
GENERAL SAFETY INSTRUCTIONS
14. Stability must be ensured. Always keep your body in balance and set the feet in a way that ensures
stability.
15. Always keep the machine in good working order. Especially keep the tooling sharp and clean to ensure
best performance. Observe the oper a�n g in struc� ons for cleaning, lubric a� ng and changing a �a chments.
16. Always disconnect the machine from the mains before performing maintenance work or replacing
machine components such as saw blade, cu �ng tool, etc.
17. Use recommended accessories only. Observe instructions in the opera � ng instruc � ons. The use of
improper accessories may be hazardous.
18. Avoid accidental start. Prior to the conne c�on of the machine to the mains make sure the power switch is
turned to "0" (OFF).
19. Never climb onto the machine. Severe injury may be caused if the machine �p s over or if you touch the
cu � ng tool.
20. Check for any damaged machine components. Before further oper a�on of th e machine, damaged guards or other
parts should be repaired or replaced to ensure they can correctly perform their intende d func�on.
21. Never leave the machine una �end ed during opera�on. Always turn o ff power supply. Do not leave the
machine un �l it has come to a complete stop.
22. Never operate the machine under the in flu ence of alcohol or drugs.
23. Before performing any work on the electrical system, on the drive motor, etc, make sure the machine has
been disconnected from power supply.
Information on occupational safety and health
Machine transport
1. The maximum weight of the machine is 164 kg.
2. For machine transport, use appropriate means of transport.
3. The machine is much heavier at its head side so there is � pping hazard during
machine transport!
Working environment
1. Suffici ent ligh � ng and ven�la� on of the working room must be ensured.
2. To ensure work can be carried out safely, the ligh�ng must have an illuminance of 300 LUX.
Sound level
1. During oper a�on, the sound level of the machine is 70 dB.
2. Depending on the material, the sound level may be even higher when drilling. So wearing appropriate ear
protec � on (e.g. ear plugs of mu ffs) is required.
Mains connection
1. The machines of the 214AB-M type are supplied including 230V, 50Hz power cord and plug.
Have the mains connec� on and any modifica�ons thereof made by a qualifi ed electrician in accordance
with se c�o n 5.3 of the EN60204-1 standard.
2. The fuse used must have a minimum amperage of 10 A.
3. For the detailed electrical data, see the machine's name plate and the wiring diagram a �ac hed to these
opera�ng instru c�ons.
4. ATTENTION : Prior to any service or set-up work or repair, disconnect the machine from the mains (pull
out the plug).
5. The yellow/green earth conductor is essen � al for the electrical safety. So make sure it is connected
correctly.