Promac 214AB-M, Руководство пользователя

Страница: 12 / 35

12
MAINTENANCE
Below, please find the essential maintenance works that can be divided into daily, weekly, monthly and semi-
annual maintenance. Neglecting the regular maintenance will result in premature wear and poor performance
of the machine.
Daily maintenance
- General cleaning of the machine by removing the chips.
- Cleaning of the spindle taper.
- Inspection of the tool for wear.
- Inspection of the safety guards for correct working order.
Weekly maintenance
- General, careful cleaning of the machine by removing the chips.
- Cleaning and lubrication of the spindle.
- Sharpening of the tool.
- Check the safety guards for correct working order and potential defects.
Monthly maintenance
- Re-tighten all screws.
- Check that all safety guards and devices are correctly mounted.
Maintenance of the vee belt
- For operation, the vee belt must have the correct tension to ensure that the motor force is optimally
transferred to the tool. Pull out the power cord! Open the belt guard. Loosen the locking screw and shift
the motor in the desired direction until the belt has the correct tension (approx. 10 mm slack).
- For vee belt replacement, loosen the locking screw, replace the vee belt and tension it as described above.
Close the belt guard!
NON-ROUTINE MAINTENANCE
Non-routing maintenance should be carried out by qualified maintenance staff. In any case, it is recommended
to contact your machine distributor.
The correct re-installation of the safety guards and devices is also considered as non-routine maintenance.
SHUTDOWN
If the drill press shall be taken out of service for an extended period it is recommended:
- to pull out the power plug.
- to clean the machine carefully and to protect it by taking preservation measures.
- to cover the machine with a tarpaulin if necessary.
DISPOSAL
General rules
For final machine teardown and scrapping, the type and composition of the materials to be disposed of should
be taken into account. In detail, this means:
- Ferrous metals and cast iron, both of which consist solely of a metal that is regarded as a secondary raw
material, must be handed over to iron works that are authorized to melt down the materials subject to the
reimbursement of the individual constituents.
- Electrical parts including power cord and electronic components that are classified as material that can be
disposed of by the municipal waste disposal service, can be handed over directly to the administration of
the waste disposal service.
- As for the storage, transport and subsequent disposal of used mineral, synthetic and mixed oils as well as
water-soluble oils and greases being considered as special waste, please contact the consortium for used
oils.
Remark : As the provisions and laws regarding waste disposal are permanently subject to changes and
modifications, the user is advised to inform himself of the valid provisions concerning the teardown of
machine tools that might deviate from the above-mentioned standards. In any case, the above-mentioned
instructions are to be regarded as general instructions that have only guideline character.