Promac 214AB-M, Руководство пользователя

Страница: 10 / 35

10
COMMISSIONING
a)
Lubricate spindle and column with PROMAC oil, item No. 100385 .
b)
Check that the surface of the work table is free form dust, chips and oil residues.
c)
Check that the tool is sharp and correctly clamped and that the workpiece has been mounted safely.
d)
Make sure that the spindle speed set is not too high and that the selected cutting feedrate matches the
work to be performed.
e)
Make sure the required preparations for operation have all been taken prior to starting operation.
NOTE - prior to commissioning
a)
The vee belt has not been factory-tensioned to avoid any deformation. Prior to use, please tension
them in accordance with the instructions on page 11.
b)
Prior to the first use, run in the machine for half an hour in idling mode and at a speed of approx. 1040
rpm.
AFTER DAILY OPERATION
a)
Turn off the machine and disconnect it from the mains.
b)
Unclamp the tool.
c)
Clean the machine and apply oil to blank parts, guideways and spindles.
d)
Cover the machine with a cloth to protect it against dust dust and dirt.
ADJUSTMENT OF THE WORK TABLE
a)
To raise or lower the work table, loosen the locking lever; the work table can now be lowered or raised
along the column via the rack.
When the table has reached the desired height, re-tighten the locking lever to avoid vibration.
b)
The work table can be rotated by 360° after the locking screw has been loosened. After adjustment to
the correct angular position, re-tighten the locking screw.
ADJUSTMENTS FOR DRILLING
a)
Adjust the drilling depth using the depth stop.
b)
Drilling feed motion is now performed by rotating the star handle.
T SLOTS IN WORK TABLE AND BASE
To ensure safe work, the workpiece must always be safely clamped on the cross table using a suitable fixture.
The work table is provided with 12 mm T slots. A comprehensive range of suitable fixtures is offered. Please
see the
PROMAC-metal working machines catalog .
Always wear safety glasses!