ProLights Z390LED, Руководство пользователя

Страница: 29 / 44

9
Z390LED
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
9 33 33-41 42 51 60
16 33 33-48 49 65 81
3.9 DMX ADDRESSING
To able to operate the Z390LED with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX channel,
adjust the start address 33 on the Z390LED. The other functions of the light effect panel are then automati-
cally assigned to the following addresses. An example with the start address 33 is shown below:
Z390LED is equipped with 2 DMX channel mode.
• Select [ Channel Mode ], press ENTER button to confirm, present channel mode will blinking on the display.
• Use UP and DOWN button to select [ Mode1 ] (9 channels mode) or [ Mode2 ] (16 channels mode).
• Press ENTER button to store.
The tables on page 13 indicate the operating mode and DMX value. The Z390LED is equipped with 3-pole
XLR connections.
3.10 CONNECTION OF THE DMX LINE
DMX connection employs standard XLR connectors. Use shielded pair-twisted cables with 120Ω impedance
and low capacity.
The following diagram shows the connection mode:
ATTENTION
The screened parts of the cable (sleeve) must never be connected to the system’s earth, as this would cause
faulty fixture and controller operation.
Over long runs can be necessary to insert a DMX level matching amplifier.
For those connections the use of balanced microphone cable is not recommended because it cannot trans-
mit control DMX data reliably.
• Connect the controller DMX input to the DMX output of the first unit.
• Connect the DMX output to the DMX input of the following unit. Connect again the output to the input
of the following unit until all the units are connected in chain.
• When the signal cable has to run longer distance is recommended to insert a DMX termination on the
last unit.
1
3
2 1 2
3
Pin1 : GND - Shield
Pin2 : - Negative
Pin3 : + Positive
DMX - INPUT
XLR plug
DMX - OUTPUT
XLR socket