ProLights Z390LED, Руководство пользователя

Страница: 28 / 44

Z390LED
8
3.4 OPERATION IN AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Select [ Show Mode ], press ENTER button to confirm, present show will blinking on the display.
• Use UP and DOWN button to select ( Show1, Show2, Show3, Show4 ).
• Press ENTER button to confirm the selection.
Press MENU button back to the last menu or idling 30 seconds to exit menu mode.
3.5 MUSIC CONTROL
• Select [ Sound State ], press ENTER button to confirm, present state will blinking on the display.
• Use UP and DOWN button to select [ On ] (sound control On) or [ Off ] (sound control Off).
• Press ENTER button to store.
In this operation mode adjust the control sensitivity for the microphone sensitivity so that the dynamic
power of the music will be reproduced in an optimum way by the movements of the light beam and the
change of the color.
Note. When changing the volume of the music system, the microphone sensitivity must be adapted accord-
ingly via the control.
• Select [ Sound Sense ], press ENTER button to confirm, present sound sense will blinking on the display.
• Use UP and DOWN button adjust the sound sensitively from 1 to 100.
• Press ENTER button to store.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave [ Slave Mode ] with the same effect.
• Select [ Slave Mode ], press ENTER button to confirm, present mode will blinking on the display.
• Use UP and DOWN button to select [ Slave1 ] or [ Slave2 ].
• Press ENTER button to confirm the selection.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 12).
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units are
connected in a chain.
3.8 DMX MODE
• Select [ DMX Address ], press ENTER button to confirm, the present address will blinking on the display.
• Use UP and DOWN button to adjust the address from 0 to 512.
• Press ENTER button to store.