HERO H150F
10
Receiver
The receiver is tested and pre-attached to the rear panel of each HERO-series model. Please do not try to
remove it. The receiver responds to up to 5 different transmitters that are registered with the machine. The
included transmitter has been registered with the machine before shipment. It can be directly operated
without any start-up setting.
A
B
Registering transmitters
To operate the machine with a different transmitter than the included one, or to operate it with up to 5
different transmitters, each transmitter must be registered first. There is an LED light on the rear control
panel of the machine. When the machine is turned on, the green LED will be flashing for 15 seconds. Dur-
ing the 15-second interval, users can register signals for one or more transmitters. For this purpose, press
the button “A” on each transmitter. If the registering signals of the transmitters are well received by the re-
ceiver, the green LED will stop flashing and light permanently. The previous transmitters are cleared from
the memory of the receiver. If no transmitter is registered while the machine is switched on, the memory
of the receiver will keep the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine. While the green LED is flash-
ing, press the button “A” on each transmitter to establish the signal transmission.
Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the machines at the same time. While
the green LEDs are flashing, press the button “A” on the transmitter to establish the signal transmission.
Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced. For this
purpose, take off the housing cover and remove the used battery. Insert a fresh 12 V battery, type 23A as
indicated in the battery compartment and refit the housing cover.
Fig.5
Fig.6
2.6 WIRELESS REMOTE CONTROL
The wireless remote control system consists of a transmitter equipped with two buttons for fog output on
and off, and a receiver pre-attached to the rear panel of each HERO-series model.
Transmitter
With the transmitter it is possible to emit fog via radio over a distance of up to 50 meters. The transmit-
ter is compatible to any receiver of the HERO-series and can control an unlimited number of machines in
parallel.
