HERO H150F
6
- 2 - FUNCTIONS AND SETTINGS
2.1 BASIC
1. Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3. Place the liquid tube into a properly filled liquid tank.
4. Fill with high-quality, water-based fog liquid recommended by Prolights dealer.
5. The HERO H150F only works with uncontaminated Prolights Fog Liquid. Any other types of liquid can
damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on
liquid tank. Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
Note:
•
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when in-
stalling your unit.
•
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or
so after being turned off.
•
All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
2.2 OPERATION
Control Panel
The built-in control panel on the rear of the machine features an LCD panel displaying all operation sta-
tuses of the fog machine. The control panel allows the user to customize fog machine functions by adjust-
ing the fogging duration, interval, and volume as well as the DMX address, the wireless function and the
fluid sensor. There are six buttons on the control board. All current operating parameters are automatically
stored in non-volatile memory, allowing the machine to be powered down without losing function set-
tings. After switching on, the display shortly indicates HERO H150F. Then the fog machine starts with the
warm-up process and the display indicates »Warming Up«. While the unit is warming up, fog output will
not be possible yet. Program the necessary menu settings with the control panel. Once the warm-up proc-
ess is completed, fog output will be possible. The display indicates »Ready to Fog«. Additionally, a »W« for
wireless and an »S« for fluid sensor is indicated if these functions are activated.
FUNCTION
VOLUME
TIMER
MANUAL
Fig.2
