ProLights ARCLED5118RGB, Руководство пользователя

Страница: 25 / 36

9
ARCLED5118RGB
3.10 DMX addressing with ID address
Where the light control unit has not enough channels for independent management of each unit installed
is still possible with the use of the ID, the autonomous control unit.
• Set on the unit, as needed, the same value DMX ( 01-50) .
• Press the [D] button or [E] button to scrolls through menu options from right to left or from left to right.
• Then press the [UP] button to set the value ( d01-d50) on the selected position.
• After the setting value is automatically saved.
Note. For DMX control without ID address to set d00.
• The channel 9 allows to select the ID address and manage independently the unit or control a group with
the same DMX value, by setting the channel 9 to “0”.
Fig.5
. . . . . . . . . . . .
DMX Address: 33
ID Address: 1
DMX Address: 42
ID Address: 3
DMX Address: 42
ID Address: 2
DMX Address: 42
ID Address: 1
DMX Address: 33
ID Address: 3
DMX Address: 33
ID Address: 2
DMX512 Controller
1
3
2 1 2
3
DMX - OUTPUT
XLR socket
DMX - INPUT
XLR plug
Pin1 : GND - Shield
Pin2 : - Negative
Pin3 : + Positive
The figure above shows a simple DMX layout which has used three units at each DMX address. The three
units have different ID addresses which allows the user to collectively control the whole group of units at
that DMX address by setting CH9=0, or to control each unit independently by first selecting the DMX ad-
dress and the by using CH9 to locate the target ID address.
Example
Selecting the DMX value 33 on the light controller:
• By setting channel 9 to “0” you can control the whole group.
• By selecting the corresponding ID address through channel 9 you can control each unit independently.
3.11 Connection of the DMX line
DMX connection employs standard XLR connectors. Use shielded pair-twisted cables with 120Ω impedance
and low capacity. The following diagram shows the connection mode: