5
ASSEMBLY INSTRUCTIONS
2. If you want to field drill the track section (F), mark location
of holes and center on track section (F). Drill a perpendicular
3/16-in. hole at marks and remove burrs. Be sure not to
damage insulators or conductors. Use mounting hardware
(not included) that does not come in contact with the
insulators or conductors to complete job.
Note: A single section of track that is 4 ft. or less in length is
to be provided with one mounting opening spaced a
maximum of 6 in. from each end of the track section (F).
Additional openings might also be provided. A single section
of track that is greater than 4 ft. in length is to be provided
with a mounting opening spaced a maximum of 12 in. from
each end of the track section (F), with additional openings
being placed a minimum of every 4 ft. along the length of the
track section (F).
5. For installing fixture on drywall ceiling, use toggle bolts
(CC). Drill a 5/8 in. hole at each mark on ceiling, insert bolts
through the track and thread toggles 1/2 in. onto bolts. Place
track section (F) against the ceiling and insert toggles into
holes until they spring open. Tighten bolts.
F
CC
Hardware Used
Toggle Bolt
x2
CC
2
5
3. Make electrical connections using wire connectors (BB).
Refer to ELECTRICAL CONNECTIONS in the Safety
Information section on page 3. Install the mounting bracket
(A) to the junction box by using junction box screws (AA).
4. Determine location and attach track scetion (F) to
mounting bracket (A) and secure with support screws (D).
Place track section (F) and
supply
connector (B) at desired
location on ceiling, noting location of electrical supply. Mark
ceiling through holes in track section (F) and remove it from
the ceiling.
Hardware Used
A
3
4
Junction
Box Screws
x2
BB
Wire Connector
x3
BB
AA
F
AA
D
F
B
A
Lowes.com
