REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA TILT 2.0 16
SERVICE MANUAL
FOOTPLATE DISTANCE
HEIGHT ADJUSTMENT EVERY 1.5cm
Remove the bolts
A
and their corresponding nuts and washers
B
.
Slide the footplate tube up or down until the necessary height.
Insert the bolts through the nearest holes and tighten.
Where present, it is possible to use the second hole
C
, too.
If necessary, you can adjust the height of the two independent footplates differently.
With one piece footplate, the two tube have, of course, to be adjusted at the same height.
The footplate tube can be either short (1) or long (2).
The short tube has two positionings for the adjustment support (RH and LH) in order to
reach short footplate distances.
The long tube has only one positioning for the adjustment support and it is design for long-
er footplate distances.
The tubes for double footplates and one piece footplates are the same, but the adjustment
support is different.
To reach the shortest footplate distance, one can, both at original assembly or afterwards,
cut off both the footplate tube and the part of the frame just below the welding as shown by
the dotted line
D
on the pictures at the top of the page.
It should be clear that the possible adjustment is then limited.
The adjustment support is fixed to the tube with the bolt
E
on which a drop of strong lock
thread glued is spread. Should you need to change the position of the support (only short
tube), in order to unscrew the bolt, you may need to heat it first. When you assemble the
support, spread a drop of strong lock thread glue on it.
After adjustment, check that between the lower side of the footplate and the ground there
is at least 2 cm and that there is no interference between footplate and casters.
Nota per il telaio abdotto
The fixing hole for the adjustment support, with respect ot the height adjustment holes, is
not rotated by 90°, but by 76°.
That is to compensate the angle of the front frame adbuction.
The tube is only short and it allows for two positions for the adjustment suport.
A
C
D
B
C
A
1
2
DOUBLE FOOTPLATE
1
2
E
ONE-PIECE FOOTPLATE
76°
76°
