ProForm PFTL17112.0, Руководство пользователя

Страница: 31 / 40

31
Most treadmill problems can be solved by follow-
ing the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
surge suppressor and that the surge suppressor
is plugged into a properly grounded outlet (see
page 19). Use only a surge suppressor that meets
all of the specifications described on page 19.
IMPORTANT: The treadmill is not compatible
with GFCI-equipped outlets and may not be
compatible with AFCI-equipped outlets.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode,
designed to be used if the treadmill is displayed
in a store. If the displays show a demo presenta-
tion when you remove the key, the demo mode is
turned on. To turn off the demo mode, see step 3
on page 27.
SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. With the help of a second
person, carefully tip the treadmill onto its side.
Next, remove the two indicated #8 x 3/4" Screws
(5). Then, tip the treadmill flat onto the floor.
Remove the three #8 x 3/4" Screws (5). Carefully
pivot the Motor Hood (59) off.
TROUBLESHOOTING
Reset
Tripped
c
5
a
5
59
5