ProCurve 800, Руководство по настройке, Страница: 156 / 406

3-28
Initial Setup of the ProCurve NAC 800
System Settings
Figure 3-14. Home > System Configuration > Management Server—SNMP
Settings Area
3. Check the Enable SNMP check box.
To disable SNMP, clear the check box.
4. Enter a read-only community name that matches your SNMP server’s in
the
Read community string
field.
Valid characters include letters, numbers, hyphens, or underscores. The
default name is
public
, which is the default for most devices and SNMP
servers (including PCM). You should change the name for more security.
N o t e
The NAC 800 does not grant read-write access to SNMP servers. However, to
properly discover the NAC 800, PCM requires both a read-only and a read-
write community name. Set both names to the name configured in the
Read
community string
field.
5. Enter a network address in Classless Inter-Domain Routing (CIDR) nota-
tion in the
Allowed source network
field.
If you do not want to restrict access to SNMP devices in a particular
network, enter
default
.
To configure Outgoing SNMP notifications, follow these steps:
1. Select the
Outgoing SNMP notifications
check box.
To disable outgoing notifications, clear the check box.
2. Enter a comma-separated list of IP addresses or hostnames that can
receive the SNMP notifications in the
Notification destinations field.
3. Enter a community string used to authorize SNMP notifications in the
Community string
field. This string must match the community string of the
system receiving the notification.
4. Check the
Resend notifications
check box, if you want notifications to be
resent until the endpoint has been disconnected, has passed all tests, or
has been granted access by an administrator. Otherwise, clear the check
box.
a. Enter the number of seconds between notification resends in the
Resend interval
field.