»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO+
proswell.fr
>>
ASSEMBLY OF THE OCTO POOL STRUCTURE (contd.)
The wooden brackets will support the coping that will be
mounted after the pool is filled. Pre-drill the wall from
inside the pool then attach each wooden bracket (type l)
using 2 screws (5x100 mm sachet l) taking care to position
them 3 mm below the top of the structure. Remove any
splinters that may have been raised during this process.
The are 3 wooden brackets per side (except the side
holding the skimmer). Position 1 wooden bracket in the
centre of the slat, the other 2 equidistant on either side of
it (distance D2 in the table).
Mount 2 wooden brackets on the wall holding the skim-
mer or filtration unit. In the case of a skimmer they should
be positioned 75.5 cm apart and equidistant from the
skimmer axis. In the case of a filtration unit, they should
be 50 cm apart.
Screw a mounting plate to the top of each wooden
bracket (wooden bracket kit) . Make sure that each plate
is flush with the top of the walls.
IMPORTANT !
Check that the structure is correctly assembled
before mounting the liner locking track.
To do this:
- use a spirit level to check that the structure is horizontal
around the entire periphery.
- check that the 4 diagonals are equal in length.
Fix any imperfections before continuing.
The liner locking track should be flush with the top of the
wooden structure.
Before mounting the liner locking track, pre-drill using a
Ø 3 mm drill bit.
Avoid over tightening, this could cause the screws to
break through the track.
8
9
10
11
12
8
