»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO+
proswell.fr
>>
ASSEMBLY OF THE OCTO+ POOL STRUCTURE (contd.)
At this point, fit the filtration system into the machined slat (F). Slot the top skimmer slat (G) over slat F and continue
around the pool, fitting 2 type H slats, 1 type l slat and 4 type J half-slats into position as shown.
Attach a decorative trim (type K) to the end of each wall
using 4 3.1x75 mm screws (bag L) inserted through holes
pre-drilled at regular intervals along the axis.
Working from the outside, screw the metallic posts
(pre-drilled) onto the wooden walls using 6x40 mm
screws from bag C. Check their verticality. Position two
decorative profiles (Q) on either side of each post and
fasten them together using 3 5x70 screws (bag C) as
shown.
The wooden brackets are designed to support the coping
after the pool is filled. Pre-drill the wall, then, working
from inside the pool, fasten each coping support bracket
(L) in position using 2 5x100 mm screws (bag l), taking
care to ensure that each bracket is 3 mm beneath the
top of the pool structure. Check the verticality of each
support bracket.
The short sides of the 460 and 540 pools should be fitted
with 2 coping support brackets
The short sides of the 640 and 840 pools should be fitted
with 3 coping support brackets, except for the side hold-
ing the filtration system which should be fitted with
2 coping support brackets. (illustration 38).
27
28
29
30
31
32
33
540 & 460
640
840
12
