»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO+
proswell.fr
55
>>
FITTING & CUTTING OUT THE LINER (contd.)
Once the liner has been hung and is correctly positioned,
fill the pool with 2 cm of water. Push any creases towards
the walls smoothing out the liner as much as possible.
This operation will not be possible if the pool is empty
or overfilled (contains more than 2 cm of water).
Stick the self-adhesive gaskets to the return fitting and
vacuum fitting flanges.
Locate the holes in the throughwall flange and mark
them.
Screw the flange (fitted with its gasket) into place using
the countersunk SS screws M5x16 from the pool fitting
skin pack. Tighten the screws alternately to ensure a
leaktight fit. Hand tighten, over tightening could damage
the flange.
51
52
53
54
Once the liner is correctly hung and positioned and
creases have been eliminated, continue filling the pool
until the water level is 10 cm below the first pool fitting
(underwater light or return fitting depending on their
position).
Cut out the liner inside the vacuum fitting and return
fitting flanges.
16
