»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO+
proswell.fr
>>
MAINTENANCE & OPERATION (contd.)
ACCESSORIES
Electrical equipment such as underwater lights that require an electrical supply must be fitted and wired in according
to the standards in effect. We recommend that you take great care in this matter and that you call on the services of
qualified specialists.
Some models come with a bubble cover that is spread over the pool while it is not in use. The action of sunlight on
the cover heats the water below and the cover helps maintain the water temperature at night. Upon removing the cover
from the pool, turn it over to allow it to dry, then roll it up and store it out of the way. Never fold the bubble cover, this
could cause it to tear. Wipe it down from time to time with a damp cloth. This cover should under no circumstances be
considered a safety device. A safety winter cover (that complies with the French safety standard NF P90-308) is available
as an option to protect the pool. This high quality product is extremely hard-wearing and attractively finished. For
storage and upkeep, follow the same instructions as for the bubble cover.
WINTERIZING THE POOL
Carry out a prolonged back wash of the filter.
The pool should not be emptied during winter (or prolonged periods while the pool is not use). The liquid mass
plays a several roles, providing thermal insulation, holding the liner and pool structure in position.
Lower the water level to about 10 cm below the bottom of the skimmer mouth.
Water can be siphoned from the pool or allowed to drain by gravity by moving the multiport valve to DRAIN. Water
will run through the waste line. Do not run the pump during this operation.
Next, disconnect the pipe underneath the skimmer so that it can act as an overflow in the event the water level rises
due to precipitation. Remove any water treatment chemicals from the skimmer (chlorine tablets, flocculents, etc.).
Unscrew the return fitting face ring from inside the pool.
Use a threaded winterizing plug or rubber plug (not provided) to block the return fitting from inside the pool.
Add an algicide and a winterizing product (not supplied) to the water.
Remove the stainless steel ladder.
Place a winter cover over the surface of the pool.
NOTE: Winterizing is not mandatory, especially if the weather is clement and temperatures remain positive. In this
case, maintain a correct water level in the pool and run filtration 2 to 3 hours per day. Check the water level in the pool
regularly.
WINTERIZING THE HYDRAULIC INSTALLATION
Disconnect the return line.
Allow water to drain from the suction and return lines.
Open the plug at the bottom of the filter and allow water to drain away. Do not replace the plug before putting the
filter back into service.
Open the drain plugs on the pump and pre-filter.
Leave the plugs open.
Cut the power supply to the filtration control panel.
In as far as possible, store the filtration group in a location protected from humidity. In the case of an unprotected
outdoor installation, remove the pump and store it.
We think that we have provided you with main information you required to use and maintain your pool, however you
will find more information in specialised guides and reviews. Don’t hesitate to consult these.
HYGIENE
As regards hygiene, there are no official regulations for family pools. However, for your health and that of your family
and friends, there are some rules that you should respect!
This begins with good personal hygiene.
Next, to maintain water purity, respect the instructions set out in the section “maintenance and operation”. Pay
particular attention to treatment cycles, water testing, filtration and cleaning. The balance of your pool water
depends mainly on you. Do not hesitate to inform yourself and follow the advice of the professionals.
26
