»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO+
proswell.fr
>>
ASSEMBLY OF THE OCTO POOL STRUCTURE
Fit the 4 half slats (type A - smooth side facing down) together with 4 male/ female slats (type B), grooves facing down,
double tongues facing up (see the detail above).
- Before you begin, familiarise yourself with the
nomenclature enclosed in the “Accessories” kit and the
exploded view (at the end of this notice) that corresponds
to your pool.
- Determine the final orientation of your pool, by preference,
the skimmers should be oriented so that they are facing
into the prevailing winds. Skimmers must be mounted on a
side that starts with a type A slat.
- While assembling the walls, make sure that each slat is fully
engaged before starting on the next.
- You may need to use a hammer and a clamp to remedy any
slight warping of the slats. Do not strike the wood directly,
use the protective brace (provided).
- During assembly, check regularly that the walls are level
and the 4 diagonals are equal in length.
- To avoid the risk of injury or damage to the liner, take care
to eliminate any splinters during and after assembly.
- If you intend to fit your pool with a counter swim unit, you
will need to incorporate the 2 slats specially prepared to
mount this option. .
At this point, fit the skimmer or filtration unit into the
bottom machined slat (type D).
In the case of a filtration unit, fit the 2 slats on either side
of the filtration unit, otherwise, fit the top skimmer slat
(type E) over the bottom skimmer slat (type D). Continue
around the pool with 3 type F slats and 4 type G half-slats
as illustrated.
Attach the finishing profiles (type H) to the exposed edge
of each wall using 4 equally spaced SS rivets (3.1x75 mm)
inserted into holes pre-drilled in the axis.
4
5
6
7
3
Fit together the remaining slats (type B) taking care to
position the slat that will hold the return fitting (type C)
and the machined slat (type D) correctly. The slat that will
hold the return fitting (type C) should be positioned over
4 type B slats + 1 type A slat in the case of a skimmer
and in the case of an autonomous filtration unit. The slat
that will hold the return fitting slat (type C) should be
positioned just underneath the machined slats. The type
D slat is positioned on the same side in the last row of
this step.
7
