Procopi Proswell Tropic HEXA, Руководство по установке

Страница: 19 / 40

proswell.fr
»
INSTALLATION INSTRUCTIONS / OCTO / OCTO + / HEXA
19
>>
ASSEMBLING AND COMMISSIONING THE FILTER GROUP
Description
Flow rate m
3
/h with
directional nozzle
Pump
Filter diameter
in mm
Sand
Filtration
surface area
in m²
Volume
filtered in
24h
TROPIC filtration 5.37 Aqua-tropic
4m
400 1x25 kg 0.125 128.9
Ref Description Ref Description
B Hose SPI 45 L Pressure gauge
D Rubber circlips O Return fitting nozzle
E Pump/filter connection hose O1 Return fitting body
G Pump O2 Return fitting gasket
I Skimmer assembly O3 Return fitting flange
I1 Skimmer lid O4 Directional jet return fitting face plate
I2 Skimmer basket P Drain plug + o-ring
I3 Skimmer gasket Q Collector pipe with cap
I4 Skimmer screw 5.5 x 25 R Collector plate
I5 Skimmer flange S Lid+6-way valve
I6 Skimmer weir V Lid holding ring
I7 Skimmer face trim W Lid holding ring o-ring
I8 Skimmer body X Diffuser
J Union under the skimmer Z Filter tank
1 Tank 1 Lid o-ring
1 collector tube with plug
1 collector plate 1 diffuser
1 drainage plug with o-ring
1 lid locking ring
1 lid with mulitport valve,
pressure gauge and unions
Before you continue to fill the pool, assemble the filtration group. Refer to the sand filter installation instructions
below and the pump operating instructions. Study the filtration system diagram and the table below that lists the main
components and the composition of the various packs.
CAUTION ! ! ! The pump power supply absolutely must be protected by a 30 mA RCD mounted upstream from the
installation.
Similarly, follow all the installation instructions set out in the manuals enclosed with the underwater light and the
electrical panel.
The filtration system, like every other electrical device, must be wired in accordance with the standards in effect in the
country of installation (C15-100 in France).
Do not hesitate to call on the services of a professional to ensure that your installation complies with all regulation in effect.
We strongly recommend that you install the filter below the water level. If the filter is installed above the water line, there
is a risk of deformation due to depressurisation. The maximum acceptable height is level with the coping. In the event
that the filter is installed above the water line, a check vent must be mounted on the return line and an inspection check
valve must be mounted on the suction line (these items are available from any pool specialist).