» INSTALLATION INSTRUCTIONS
/ OCTO / OCTO + / HEXA
12
proswell.fr
>>
ASSEMBLY OF THE OCTO + POOL STRUCTURE (contd.)
Recommendations and advice:
- Before beginning assembly, identify the various slat types with reference to the exploded view at the end of this
document.
- Establish the final orientation of your pool, the skimmer should be oriented facing into prevailing winds. The skimmer
should be mounted on a side that starts with a type A slat.
- While assembling the walls, make sure that each slat is fully engaged before starting on the next.
- You may need to use a hammer and a clamp to remedy any slight warping of the slats. Do not strike the wood directly,
use the protective brace (provided).
- During assembly, check regularly that the walls are level and the 4 diagonals are equal in length.
- To avoid the risk or injury or damage to the liner, take care to eliminate any splinters during and after assembly.
- Please refer to the various illustrations provided in this document.
- If you intend to fit your pool with a counter swim treadmill, you will need to incorporate the 2 slats specially prepared
to mount this option.
Fit together the two type A half slats and the two type C
half slats and the 4 type B slats as shown in the diagram,
with the male side (tongue side) facing up.
Fit the remaining slats together using type B slats on the short sides and type D slats on the long walls. Take care to
correctly position the pierced slats (type E) that will hold the return and vacuum fittings, the machined slat (type F). (Refer
to the exploded view at the end of this document for the position of these slats). The slat that will hold the return fitting
(E) should be positioned above 4 type B slats + 1 type A slat. The type F slat should be located above the return fitting
slat in the last row at this point in the assembly procedure.
For the +510 model, the oblique sides are comprised of type L slats, see the diagram above.
26
27
Pools +540 & +640
B - D
E - L
G - H - I
A - C
PROFIL DEMI -FEMELLE
J
Pool +510
Fit together the two type A half slats and the two type C
half slats and the 4 type L slats as shown in the diagram,
with the male side (tongue side) facing up.
510 pools
wall (L)
510 pools
wall (L)
Fit together the two type A half slats and the
two type C half slats and the 4 type B slats
as shown in the diagram, with the male side
(tongue side) facing up.
A
B
C
D
+450
4.16
2.78
3.76
4.31
+540
4.88
2.78
4.28
5.01
+640
5.89
3.50
5.20
6.07
+510
4.59
3.02
4.28
4.81
Overview
Schematic
SEMI-FEMALE
PROFILE
MALE/ FEMALE
PROFILE
FEMALE
PROFILE
MALE
PROFILE
