www.usaprocom.com
200047-01A
16
INSTALLATION
6. Place pin on log #5 into hole in the left side
of log #1 as shown in Figures 16 and 17,
page 17.
7. Place log #6 into cutouts in log #1 and log
#2 as shown in Figure 17, page 17.
8. Place pin on log #7 into hole in the right side
of log #1 as shown in Figures 16 and 17,
page 17.
IMPORTANT:
Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation,
and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to high, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the
logs exactly as instructed. Do
not modify logs. Use only logs
supplied with heater. Each log
is marked with a number. This
number will help you to identify
the logs when installing. Do not
place any decorative cinders on
logs or burner.
1. Remove nylon ties connecting the pack-
ing material to the logs. The log number
is marked on the back of each log.
2. Place pins on log #1 into holes in rear
bracket as shown in Figures 14 and 15.
3. Place pins on log #2 into slots in middle
bracket as shown in Figures 14 and 15.
4. Place pins on log #4 into holes to the left
of the burner as shown in Figure 14 and
Figure 16, page 17.
5. Place pins on log #8 into holes to the right
of the burner as shown in Figure 14 and
Figure 16, page 17.
INSTALLING LOGS
Holes for
Log #4
Holes for
Log #1
Holes for Log #3
Log #2
Log #1
Log #3
Slots for
Log #2
Holes for
Log #8
Figure 14 - Log Base and Chassis
Figure 15 - Log #1, #2 and #3
