13
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
12
Visit
www.probrite.com/install
for installation video tutorials and product support
Installation (continued)
Installation (continued)
For Direct to Wall:
☐
Align the extension arm (AA) holes with the
holes pre-drilled in the wall.
☐
Use proper bolts or wall anchors, for the type
of wall (provided by others), and tighten to
sufficient torque setting.
☐
Consult with qualified electrician to determine
best mounting method and bolts for wall
mount.
☐
Place electrical wires through the center hole in
the extension arm (AA).
Wall bolts
provided
by others
CAUTION:
Do not use the bolts included in
the hardware kit for direct to wall (they are
intended for pole mounting. Use bolts or
screws and anchors suitable for the wall's
surface material. Consult with qualified
electrician to help determine best mounting
method and bolts for wall mount.
6B
Making electrical connections
(fig 3).
ON/OFF Wiring (Non Dimming) Method:
☐
Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
☐
Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (BB).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
0-10V Dimmable Wiring Method:
☐
Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
☐
Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (BB).
☐
Connect the purple wire to the (V+)
DIM wire and the gray wire with (V-)
DIM wire by twisting the exposed wire
together and using the wire nuts (BB).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
(+)DIM V+
BLACK
WHITE
PURPLE
GROUND
GRAY
GREEN
(-)DIM V-
(Non-Dimming Wiring Diagram)
(0-10V Dimming Wiring Diagram)
TIP:
Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
☐
If necessary, strip 3/8" of insula-
tion from junction box or fixture
(A) wires (fig 1).
NOTE:
The light fixture has precision Type IV
forward throw optics so when using extension
arm mount keep fixture in the 0° position.
