15
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
14
Visit
www.probrite.com/install
for installation video tutorials and product support
Care and Cleaning
☐
Shut off main power supply before cleaning the product. To prolong the original
appearance, clean the light fixture with clear water and a soft, damp cloth only.
☐
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
Possible Cause
Solution
Light does not
turn ON
No power to the fixture
Check if circuit breaker is tripped
Confirm wall switch is On Verify
wiring to fixture is correct (turn
power off to fixture beforehand)
Fixture is sensing daylight
Cover photocell. Wait several
seconds until fixture turns ON.
Light cycles
ON and OFF
continuously
Photocell light sensor is sens-
ing reflected light
Relocate light fixture to a location
where there is no reflected light.
OR place the optional photocell
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light
FLICKERS
The light fixture is wired
through an unsuitable dimmer
Replace the dimmer with a 0-10V
dimming switch or a standard
ON/OFF wall switch.
Light stays ON
Light sensor is in a shaded
area
Shine a flashlight into the light
sensor and wait a couple minutes.
If the light turns OFF, the fixture
should be moved to a location
with enough light in the daylight
hours for the light sensor to work.
OR place the optional opaque
cover over the photocell light
sensor and use the wall switch to
turn the light ON and OFF.
Light Sensor is faulty
If the light does not turn off when
a flashlight is shined on the light
sensor for a few minutes, then
the sensor may be faulty. Please
contact customer service.
OPTION 2: SWITCH CONTROLLED
Switch controlled operation enables the light fixture to
turn ON and OFF by flipping a switch that controls the
electricity to the outlet powering the fixture. The light
fixture will not turn ON and OFF automatically, but is
manually controlled.
☐
To enable switch activated operation put
the black cover label on the photocell.
SWITCH
CONTROLLED
NOTE:
If photocell (B) is located in an area
under heavy shade the photocell may not
detect enough light and may turn the light
fixture on.
TIP:
To test if the light fixture (A) and pho-
tocell (B) works properly run power to the
fixture and cover the photocell to turn fixture
ON. Shine a light into the photocell to see if
fixture turns OFF.
☐
To enable dusk-to-dawn operation make
sure the photocell (B) is exposed to light
and is unobstructed.
☐
Ensure the switch powering the outlet
connected to the light fixture is turned
to the ON position and
leave it ON
at all times to enable dusk-to-dawn
functionality to operate automatically.
A
Operation
1
Selecting Dusk-to-Dawn or
Switch-Activated control
OPTION 1: DUSK-TO-DAWN OPERATION
Dusk-to-dawn operation enables the light fixture to automatically turn
ON when dark outside and turn OFF when the sun rises, thus saving you
energy.
E
AUTOMATIC
NIGHTTIME ON
DAYTIME OFF
Place included
photocell cover
(EE) to cover the
clear window to
disable dusk to
dawn operation
A
E
EE
NOTE:
Photocell (E) must be installed on fixture for both
dusk-to-dawn and switch controlled operation. Fixture will
not work if photocell is not installed.
NOTE:
Photocell (E) has a few minute delay, to reduce it's sensitivity to
sudden light changes. When testing shine a light/cover the photocell
for a few minutes to check if fixture functions properly
