Display screen and function definition
Time—In the operation of quick start up, the exercise time was count from 00:00, end to 99:59. During this
program, the user set time by press
“
+
”
or
“
-
”
. The section number of program will divide the time
evenly. Note: the last time entering into it should be default value transfer of time.
Speed- The current speed renew each 3 seconds, to be more exactly, one tenth mile/kilometers per hour.
Average speed- It’s the average speed of current exercies mile/kilometer,the display renews each 3
seconds, one tenth mile/kilometer per hour.
RPM- Display the pedal rotating time every minute. The feature of pedal RPM renew each 3 seconds. It
can display precise to 1 RPM.
Distance- the general distance display one tenth mile/kilometer.
Calories-under the distance, to test the calories of consumed, it can display precise to 1 calories.
Heart rate- hand-holding/contact testing the heart rate. (computer connect the heart rate accepting deive of
telecontrol, at the same time, it is with the inside heart rate accepting device. Using the priority circuit to
telecontrol and check the signal of heart rate. If the heart rate signal can not be received, the resistance
grade will display on the heart rate window. The singular LED willflash the sigal of heart rate it received.
The acceptor should be consistent with the sendor of international trademark 5KHZ.)
Resistance level- resistance level 1-16 will display on heart rate window within the first 5 seconds. Then
user can change the resistance level manually. If there is signal, the heart rate will be displayed on screen.
Watts- it will display the current power input such as watt. The power will renew every 3 second, the value
precise tl 1 watt.
Mets-consumed value- value of oxygen-consumed. These program is as the same as the computer
used.
Segment time- at the time window, it will display the reman time of program section. Use “Enter“ key to
change the displaying window.
Button function:
Scan- Computer with two scan key. One key control Distance, Calories and Average Speed. The other
SCAN key control Speed, RPM, Watts and Mets value. Each time pressing Scan LED, the light will flash.
Each numerating device display each 5 seconds. Pressing the Scan key again, the display window will
save all the selected read-out.
Enter- Under program setting mode, confirm these value by pressing this key then begin to exercise. The
information include Program, Time, Age, Weight and target heart rate.
+/- key –For selecting time, program, age, weight, target heart rate and resistance level.
Reset- For computer entering into program setting mode at any time.
Quick Start - pressing quick start key, system begin running resistance level 3. Dot matrix like the
operation running of heart rate control program, the running section turn into the current right section.
Because Time do not enter into this program, the section of dot matrix will enter into a new line 60 seconds
later.
Program Operation:
Program set mode:
When turning on the power supply of computer, dot matrix display WNQ, the number scroll. Then select
one program and press
“
+
”
/
“
-
”
to set, or press quick start key directly.
Press
“
+
”
/
“
-
”
to set program:
When the program selection is displayed, the program name (the following list)should be displayed
onm the certer of number.
Computer enter into
“
P2
”
program by pressing
“
+
”
or
“
-
”
key, After the computer displayed , press
enter key indicate that the user enter into weight selection.
Содержание 8318 WB
Страница 1: ...8318 WB USER S MANUAL...
Страница 15: ...10 Explosion drawing...
