-
A slight production of noise on the belt or motor is due to the construction and has no negative
effects upon operation.
-
Do not use corrosive or abrasive materials to clean the equipment. Ensure that such materials are
not allowed to pollute the environment.
-
Please ensure that liquids or perspiration never enter the machine or the electronics.
-
Before use, always check all screws and plug-in connections as well as respective safety devices
fit correctly.
-
Always wear suitable shoes and clothes when using the equipment.
-
Please do not leave especially radiation – intensive appliances (e.g. mobile telephones) directly
next to the cockpit or the electronic control-system as otherwise values displayed might be
distorted (e.g. pulse measurement).
-
To avoid injuries in case of emergencies, always make sure that you have enough space behind
your exercise bike (min. diameter 1.5m)
-
Make certain that no other persons are in the area of your exercise bike, because they may be
injured by the moving parts.
1.3 Instructions for assembly
-
Ensure that you have received all the parts (see check list) and that they are undamaged. Should
you have any cause for complaint, please contact your dealer.
-
Unpack all individual parts and place them alongside each other on the floor. Be sure to place them
on carton or a pad to prevent scratches either on the parts or on your floor.
-
Make certain that you have adequate room for movement (at least 1 m) on all sides during
assembly.
-
Place the equipment (for assembly and use later) on a solid and flat surface.
-
Before assembling the equipment, study the drawings carefully and carry out the operations in the
order shown by the diagrams. The correct sequence is given in capital letters if necessary.
-
The equipment must be assembled with due care by an adult person. If in doubt call upon help of a
second person, if possible technically talented.
-
Please note that there is always a danger of injury when working with tools or doing manual work.
Therefore please be careful when assembling this machine.
-
Ensure that your working your working area is free of possible sources of danger, for example don’t
leave any tools lying around. Always dispose packing material in such a way that it may not cause
any danger. There is always a
risk of suffocation
if children play with plastic bags!
-
The fastening material required for each assembly step is shown on the diagram inset. Use the
fastening material exactly as instructed. The required tools are supplied with the equipment.
-
Bolt all the parts together loosely at first, and check that they have been assembled correctly.
-
Tighten the locknuts by hand until resistance is felt,
then use spanner to finally tighten nuts
completely against resistance (locking device).
Then check that all screw connections have
been tightened firmly.
-
For technical reasons, we reserve the right to carry out preliminary assembly work
(e.g. addition of tubing plugs)
Please keep original packing of this article, so that it may be used for transport at a later date, if
necessary.
1.4 Order of spare parts
-
When ordering spare parts, always state the full article number, spare part number and quantity
required.
-
Example order: Art.no. 8318WB / spare part no. 12 / 2 pieces.
-
Important:
spare part prices do not include fastening material; if fastening material (bolts, nuts,
washers etc.) is required, this should be clearly stated on the order by adding the words
“with
fastening material”
This training equipment is for use at home only. The equipment complies with the requirements of
DIN EN 957 – 1/5 Class SB. The CE marking refers to the EU Directive 89/336/EEC and 73/23/EEC.
2. General
Содержание 8318 WB
Страница 1: ...8318 WB USER S MANUAL...
Страница 15: ...10 Explosion drawing...
