24
Navigation and Anchor/All Around Lights
The navigation and anchor/all around lights are required to be used for operation at night or under low
visibility conditions to indicate your position to other boaters. Visually check the operation of your
navigation and anchor/all around lights and verify that the lights are free from obstructions. You should
check your navigation lights monthly during optimum visibility conditions.
•
When you are underway in low visibility conditions, you should have the Nav. Lts. switch
in the up or forward position. This will activate the navigation lights, as well as your
anchor/all around light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor/all
around light. Press the Nav. Lts. switch to the down or aft position to turn on the
anchor/all around light.
The navigation lights consist of a pair of stainless steel lights that are
mounted at the bow of the boat. The red light is installed on the port side
and the green light is installed on the starboard side.
If you have selected the optional hard top, the anchor/all around light will be
mounted on the center of the fiberglass top. If you have not selected the
optional hard top, the anchor/all around light will be mounted on the
windshield frame. This light must be secured in the up position when you
are underway.
Remote Spot Light (Optional)
The installation of the remote spot light requires the optional hard top. The remote spot light is mounted
to the forward area of the fiberglass top. To operate the remote spot light, locate the remote spot light
panel that is installed on the console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located
in the center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the
all around toggle lever (on the left side of the panel) can be moved in an up, down, left or right position to
rotate the light assembly in the desired direction.
Spreader Lights and Courtesy Light (Optional)
The installation of the spreader lights and the dome shaped courtesy light requires the optional hard top.
The spreader lights are mounted to the aft side of the hard top frame, along the top edge. The courtesy
light is mounted to the bottom of the hard top electronics box.
Remote Spot
Light
Remote Spot
Light Control
Panel
