20
plugging into shore power. The AC main breaker is located on the AC panel on the port
aft cabin wall.
Please refer to the owner’s manual provided by the manufacturer of the shore power unit for operational
procedures and for information related to the care and maintenance of their product. When in doubt,
always defer to the shore power manufacturer’s instructions and/or recommendations.
Circuit Breakers
Circuit breakers and/or fuses protect the wiring on your 28 Express. In the event a device stops working,
check to see if the circuit breaker is tripped or if the fuse is blown. Breakers are installed in the following
locations:
•
The main breaker is located above the dual battery switches and is accessible via the
battery switch hatch located below the transom sink (see photo of the battery selector
switches).
•
Additional breakers and/or fuses for the bilge pumps, trim tabs, and stereo memory are
located next to the main breaker.
•
Additional breaker switches are also located on the switch panel above the individual
switches. See the Switch and Breaker Panel information later in this section for
additional information.
A tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the on position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
Switch and Breaker Panel
The switch and breaker panel is located on the console and is equipped with 16 switches. The numbers
shown above or below each switch in the photo below correspond with the descriptions provided for each
switch:
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
