Trim Tab Indicator Switch
The trim tabs come with a trim tab indicator switch when trim tabs are
factory installed. The waterproof indicator and switch lights up to let
you know exactly where your trim tabs are.
Power Pole (Optional – Requires Jack Plate)
PREPARATON:
Always make sure the Power-Pole™ is in the full up position with a travel
strap in place when on the trailer. If any debris gets caught around the Power-Pole™,
disconnect
power from motor and remove any debris.
OPERATION:
• In the event of pump failure, the Power-Pole™ may be manually raised by
applying enough pressure to bypass the Pole-Protector valve thus allowing the unit to come all
the way up to the stowed position. If the Power-Pole™ is beyond reach it can be forced up by
driving the boat to shallower water. Depressing the up button on the Power-Pole™ control
may offer assistance.
•
Be sure to have the Power-Pole
TM
in the full up position when using outboard
motor at high speeds.
•
Keep your hands and clothing completely clear of the Power-Pole
TM
at all times.
•
Do not use the Power-Pole
TM
as a step or handle to enter or exit the boat.
•
Never allow children to play with or around the Power-Pole
TM
.
•
Never leave your boat unattended with the Power-Pole
TM
as the primary
anchorage.
•
In high wind or rough seas, the Power-Pole
TM
may relieve holding pressure to
protect the transom.
Per the manufacturer of the Power-Pole
TM
, the pole reaches a depth of 8 feet in sand and 7 ½ feet in grass. It
takes approximately 6 seconds from full up to 8 feet deep.
Caution: Hydraulic lines always have pressure. Disconnecting the lines will cause sudden high-
pressure leakage and Power-Pole
TM
failure, which may cause bodily harm.
Trolling Motor Wiring and Breaker Plug - 24V or 36V (Optional)
Each boat can be pre-wired for the installation of a trolling motor. The wiring includes the installation of a breaker
and a plug to accommodate either a 24 Volt or 36 Volt trolling motor. The wiring plug/outlet for the trolling motor
is located on the forward casting deck, starboard of the anchor locker hatch.
Trolling Motors (Optional)
The optional trolling motor will be installed at the bow and you may select either the Great White SW 109 or the
Great White SW 82 trolling motor. The SW 109 comes with a 3-bank battery charger while the Great White SW
82 comes with a 2-bank battery charger. Just plug the outlet into the wiring receptacle mounted on the forward
casting deck, starboard of the anchor locker hatch. The battery charger for the trolling motor will be installed.
15
