© Pro-Ject Audio Systems · Pro-Ject Speaker Box 10 E · Revision 1.1
5
Potential incorrect use and fault conditions
No signal on one or both channels:
Make sure that amplifier is turned on and source is working properly.
No connection between speaker and amplifier. This could be due
to a faulty plug, broken wire or or simply loose plug/socket connection.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved, the unit be sent to
the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
PRO-JECT is a Registered Trademark of
H. Lichtenegger.
This guide was produced by:
Pro-Ject Audio Systems
Copyright
©
2013. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
