© Pro-Ject Audio Systems · Pro-Ject Speaker Box 10 E · Revision 1.1
4
(BLACK) terminal on your amplifier. Repeat the instructions for the left-hand channel. Do NOT connect more
than one loudspeaker to one terminal on your amplifier.
!
Please set the volume level to minimum before switching on the amplifier!
Phasing
Providing that you have followed the connecting instruction correctly the loudspeakers should
be in phase and provide solid stereo images. If however, you have any doubt as to the phasing of the
loudspeakers, try reversing the connections (RED & BLACK) to ONE of the loudspeakers, and play a
recording which has plenty of deep bass operating both loudspeakers simultaneously with the stereo
amplifier switched to „mono“. The correct polarity is indicated by firm full bass, when incorrect, the bass will
be noticeably much weaker.
Service
No routine attention is required to the working parts of the loudspeakers and being very reliable
loudspeakers rarely require service. Any service problems should in the first instance be referred to your
dealer.
Technical specifications Pro-Ject Speaker Box 10 E
Enclosure type
bass reflex via rear firing port
Recommended amplifier power:
10 to 150 watts
Frequency response:
50Hz - 20kHz
Nominal impedance:
4 ohms
Sensitivity:
90dB (1w /1m)
Chassis:
1” silk dome tweeter
4,5” paper cone bass/mid (2 pc.)
Dimensions H x W x D:
920 x 140 x 190 mm (excluding spike feet)
945 x 140 x 190 mm (including spike feet)
Weight:
11,7kg each
