7
5. Identify the Right Handlebar (48), which is
marked with an “R” sticker.
While a second person holds the Right
Handlebar (48) near the Upright (3), tie the pull
wire to the right pulse wire (A), and then pull it
upward out of the top of the Upright. Then, untie
and discard the pull wire.
Slide the Right Handlebar (48) onto the Upright
(3).
Attach the Right Handlebar (48) with two M6 x
38mm Button Bolts (53), two M6 Split Washers
(43), and two M6 Locknuts (54).
Make sure that
the hexagonal holes are in the indicated
location.
Attach the Left Handlebar (47) in the same
way.
Orient the Water Bottle Holder (49) as shown.
Insert the Upper Wire Harness (32) and the right
and left pulse wires (A, B) through the Water
Bottle Holder.
Slide the Water Bottle Holder (49) onto the
Upright (3) and attach it with an M4 x 16mm
Screw (40).
Do not tighten the Screw yet.
5
4
4. While another person holds the Upright (3) near
the Frame (1), connect the Upper Wire Harness
(32) to the Lower Wire Harness (31).
Tip: Avoid pinching the wire harnesses.
Gently pull the upper end of the Upper Wire
Harness (32) to remove the slack, and slide the
Upright (3) onto the Frame (1).
Attach the Upright (3) with four M8 x 20mm
Button Screws (35) and four M8 Split Washers
(36).
35
35
36
32
31
36
48
54
43
53
32
49
47
B
A
Hexagonal
Holes
40
3
3
1
Avoid pinching the
wire harnesses
Right
Pulse
Wire
Pull
Wire
Pull Wire
