9
11
12
13
4
6
6
1
11. Have another person hold the Upright (4) near the
front of the Frame (1). Locate the wire tie (see the
inset drawing) in the Upright. Tie the lower end of the
wire tie to the Wire Harness (28). Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Attach the Upright (4) to the Frame (1) with three
M8 x 15mm Screws (42).
Be careful to avoid pinch-
ing the Wire Harness (28).
13.While another person holds the Console (6) near the
Upright (4), connect the console wire harness to the
Wire Harness (28). Insert the excess console wire har-
ness into the Upright.
Attach the Console (6) to the Upright (4) with four
M4 x 16mm Screws (64).
Be careful to avoid pinch-
ing the wires.
Console
Wire
Harness
12.The Console (6) requires four “D” batteries
(not included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm to
room temperature before inserting batteries into
the Console. If you do not do this, the console dis-
plays or other electronic components may become
damaged.
Press the tab on the battery cover and
remove it. Insert four batteries into the Console as
shown.
Make sure that the batteries are oriented as
shown by the markings on the battery cover.
Then,
reattach the battery cover.
42
64
64
42
Batteries
Avoid pinching the
Wire Harness (28)
during this step
Avoid pinching
the wires during
this step
Battery Cover
28
28
4
28
Wire Tie
