7
8. Apply a generous amount of the included grease to
the Pivot Axle (40). Then, orient the Backrest Bracket
(13) near the Seat Carriage (3) as shown.
Pull the Backrest Knob (32) and insert the Backrest
Bracket (13) into the Seat Carriage (3). Then, release
the Backrest Knob into one of the adjustment holes in
the Backrest Bracket.
Make sure the Backrest Knob
is engaged in one of the adjustment holes.
Slide the Pivot Axle (40) through the Backrest Bracket
(13) and the welded tube on the Seat Carriage (3).
Then, tighten an M8 x 15mm Screw (42) with an
M8 x 18mm Washer (41) into each end of the Pivot
Axle (40).
8
42
Adjustment
Hole
Grease
13
3
41
40
42
41
32
7. Attach a Dumbbell Cradle (33) to the side of the Seat
Carriage (3) with two M4 x 10mm Screws (54).
Repeat this step for the other three Dumbbell
Cradles (33).
7
33
54
33
3
