23
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries.
To replace the batteries, see assembly step 7 on
page 9.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the parts
described below.
See assembly step 5 on page 8. Using a standard
screwdriver, release the tabs along the bottom edges
of the Rear and Front Shield Covers (9, 19), remove
the two M4 x 12mm Screws (61), and then remove the
Rear and Front Shield Covers.
Locate the Reed Switch (21). Turn a Crank Arm (70)
until a Pulley Magnet (16) is aligned with the Reed
Switch. Slightly loosen the indicated M4.5 x 12mm
Flange Screws (63).
Slide the Reed Switch (21) slightly closer to or away
from the Pulley Magnet (16), and then retighten the
M4.5 x 12mm Flange Screws (63). Turn the Crank
Arm (70) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
63
21
16
70
MAINTENANCE AND TROUBLESHOOTING