24
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, you must remove the parts
described below.
Using an adjust-
able wrench, turn
the Right Pedal (26)
counterclockwise
and remove it. Then,
using a standard
screwdriver, release
the tabs around the
edge of the right
Access Disc (10),
and then remove it
from the Right Shield (18).
See assembly step 5 on page 8. Using a standard
screwdriver, release the tabs along the bottom edges
of the Rear and Front Shield Covers (9, 19), remove
the two M4 x 12mm Screws (61), and then remove the
Rear and Front Shield Covers.
See the EXPLODED DRAWING on page 27.
Identify the Left and Right Shields (17, 18). Remove
all of the screws from the Left and Right Shields; there
are two sizes of screws in the Shields—note which
size of screw you remove from each hole. Then,
gently remove the Right Shield.
Loosen the M6 x 20mm Hex Screw (60). Then, tighten
the M10 x 50mm Hex Screw (33) until the Drive Belt
(23) is tight.
When the Drive Belt (23) is tight, tighten the
M6 x 20mm Hex Screw (60).
Then, reattach the parts that you removed.
26
18
10
23
60
33