Pro-face FP-3710K Series, Руководство пользователя

Страница: 92 / 104

Chapter 9 Troubleshooting
9-7
9.2 Error Message
This section explains the messages that appear when an error has occurred in the
FP unit during RUN mode.The problem causing the error message and its
related countermeasure are explained in the table below.
(Only the latest error message will appear on the FP screen)
9.2.1 Error Message List
Error Message Problem Solution
Out of range
Signal timing has been input
that is not compatible with the
FP unit.
Set the FP Output settings so that they match the
PC’s frequency and resolution.
The dot clock has greatly
exceeded of the FP units usable
timing range.
Resolution has been set that is
not compatible with the FP unit.
No signal
The PS-2000B unit, PL-3000B
unit or a Windows-compatible
PC's power has not been turned
ON.
Turn on the PS-2000B unit, PL-3000B unit or a
Windows-compatible PC’s power.
The PS-2000B unit, PL-3000B
unit or a Windows-compatible
PC has not been correctly
connected to the FP unit.
Connect the RGB cable or DVI-D cable correctly.
SEE
4.1.3 Interface Specifications (page4-5)