Moog Components Group
4 Port 10/100/1000 Mbps Ethernet Switch
February 23, 2009
(201640-xxx)
Page 9 of 13
11(FIBER LINK)
LOW to indicate a valid link between the onboard MAC and PHY.
12(FIBER DUPLEX)
LOW to indicate a FULL DUPLEX link between the onboard MAC and PHY.
HIGH to indicate HALF DUPLEX.
13(PORT1 100)
LOW if PORT 1 is operating at 100Mbps. HIGH otherwise.
14(PORT1 1000)
LOW if PORT 1 is operating at 1000Mbps. HIGH otherwise.
15(PORT2 100)
LOW if PORT 2 is operating at 100Mbps. HIGH otherwise.
16(PORT2 1000)
LOW if PORT 2 is operating at 1000Mbps. HIGH otherwise.
17(PORT3 100)
LOW if PORT 3 is operating at 100Mbps. HIGH otherwise.
18(PORT3 1000)
LOW if PORT 3 is operating at 1000Mbps. HIGH otherwise.
19(PORT4 100)
LOW if PORT 4 is operating at 100Mbps. HIGH otherwise.
20(PORT4 1000)
LOW if PORT 4 is operating at 1000Mbps. HIGH otherwise.
21(FIBER SD)
LOW if the onboard fiber module is receiving light from the opposite end of the
link.
22(FIBER 1000)
LOW if the onboard MAC
PHY link is operating at 1000Mbps. HIGH
otherwise.
MC RX
LOW if the board is receiving RS-485 diagnostic data.
MC TX
LOW if the board is transmitting RS-485 diagnostic data.
JUMPERS
: There are no jumpers on the 4 Port 10/100/1000 Mbps Ethernet Switch.
