7
■
Cold water capacity: up to 1500 lpd
■
Cold water tank volume: 0.35 gal (1.3 l)
■
Cooler power: 85W
■
Hot water capacity: up to 144 lpd
■
Hot water tank volume: 0.18 gal (0.7 l)
■
Heater power: 420W
Weight and size:
Size (WDH): 10.2 x 13 x 40” (26 x 33 x 101 cm)
Weight, without water: 37.5 lbs (17.0 kg)
Warranty:
1 year limited warranty
Package contents:
(1) Point-of-use water dispenser
(1) Universal worldwide adapter ball valve (G1/2” - G3/8” - UNEF 9/16”-24 - JG 1/4”)
(1) Teflon tape roll
(1) Drain saddle
(1) Wrench
33 ft (10 m) Water tubing ¼”
(1) ¼” x ¼” Union check valve
(1) ¼” x ⅜” Union elbow fitting
User’s guide
Installation
Notes:
1. Shut off the cold water supply under the sink or the location where the system will be
installed. If the existing valve is inoperable, the water supply to the house must be shut
off. Then, relieve the water pressure by opening the cold water tap. Do not connect the
system to hot water source.
2. Depending on your plumbing system and tubing path you may need to use tools like vari-
able speed drill, drill bits, screw driver, wrench, etc. You may want to ask a professional
service provider such as certified plumber to install the inlet valve adapter, the drain sad-
dle and the tubing conduits to assure a trouble-free setup.
3. During installation you will need to cut the supplied ¼” or extra purchased 3/8” tubing
into segments as needed. Use your utility knife for that or similar tool. See the following
charts to determine the connection scheme and length of hoses necessary. You may need
to purchase extra tubing for far-reaching or other corner case installations.
4. Do not connect the dispenser to the electrical supply until the setup is completed.
5. With initial operation, check for leaks. If a leak is observed, verify that the tubing is pushed
into the quick fitting far enough to seal the tubing against the O-ring and that the tubing
was cut at 90
o
.
