Cradle Side-Table Assembly
Getting Started
16
Place the first bracket
on the cradle by
unscrewing the four nuts
located at the metal ring
with the 4 legs of the
cradle. Note that the top of
the brackets will have to
point outward to the sides.
Put each metal support
bracket on the outside of
the leg placing the upper
hole of the bracket through
the screw while replacing
the nut in position. Don’t
tighten yet and don’t place
the bottom screw;
adjustment may be
required.
Place one (D) long screw from the outside of the bracket through the sliding
hole of the shelve hinge. The screw must be placed in from the outer part of
the bracket. Make sure that you insert the long screw into the copper ring
spacer before inserting into shelve hinge. Repeat the same on the other
bracket hole. Secure the screws with a nut and black washer (in between
shelve and bracket) on the top screw and a nut on the bottom screw.
The last step is to secure the
brackets with the large short
screw and the nut
accompanying it.
Hardware
A) 4 Short Screws
B) 4 Black Washers
C) 4 Large Nuts
D) 8 Long Screws
E) 8 Small Nuts
Other
(8) Copper Ring Spacers
(4) Black Brackets
