PREVOST X3-45 2017, Руководство оператора

Страница: 34 / 227

Coach Interior
PA1627 X3-45 Operator’s Manual
3-6
PASSENGER SEAT EQUIPMENT
Passenger seat backrests can be reclined by
lifting the reclining backrest handle. Lift and hold
the handle, then adjust backrest to the desired
angle. Release the handle to lock backrest in
position.
A folding armrest is installed on the aisle side of
the passenger. Another folding armrest is located
between the two seats and can be raised for
passenger convenience.
PASSENGER SEAT BELT
Passengers are strongly advised to wear seat
belts at all times. Children can use a passenger
seat belt as long as they are large enough to
properly wear the seat belt. The shoulder belt
must be correctly positioned over the child’s
shoulder and it must not touch the neck or lie
below the shoulder.
To fasten, pull seat belt out of the retractor and
insert the latch plate into the buckle until it clicks.
No special adjustment is required since the
retractor device is self-adjusting. If the seat belt
operation becomes defective, report to
maintenance personnel immediately.
ELR/ALR Retractor Lock Mode
Passenger seat belts are equipped with
switchable ELR/ALR retractor lock mode:

Emergency Locking Retractor (ELR)
mode:
Allows the seat belt to extend and
retract to allow passengers some freedom of
movement in the seat. Locks only when the
vehicle or occupant slows quickly/abruptly or
stops suddenly.
Will not secure a child safety
seat
.

Automatic Locking Retractor (ALR)
mode:
Locks and maintains a fixed seat belt
(lap belt) length during use. The belt cannot
be extended further.
For use with a child
safety seat .
CHILD RESTRAINT SYSTEMS
Occupants under 40” height must use Child Seat /
Booster
The seat belts are equipped with switchable
ELR/ALR retractor lock mode.
Activate the ALR retractor lock mode to hold a
child restraint system by pulling the shoulder
belt all the way out. Allow it to retract to
desired length. Check that the belt straps are
fully tightened and the retractor / webbing is
locked.
Note: Unbuckling the belt and allowing it to
retract fully deactivates the ALR retractor
Failure to use the ALR lock mode will result in
the child safety seat not being properly
secured.
When using a booster seat , do not pull the
shoulder belt all the way out. Doing so would
engage the ALR lock mode which is not
recommended with booster seat.
Install the child seat/booster according to the
manufacturer’s instructions.
SEAT RECONFIGURATION FOR MOBILITY
DEVICES
The layout features four (4) sliding, flip-up, and
two (2) fixed flip-up, two-passenger seats.
They are placed in the center section for easy
reconfiguration to accommodate mobility devices.