PREVOST LE MIRAGE XLII, Руководство по обслуживанию

Страница: 890 / 1342

Section 18: BODY
PA1553
26
o
Apply masking tape before applying Sika
glue to protect paint and adjacent window
during surface treatment.
For gluing of upper lateral window, refer to
procedure
PR290016 included at the end of this
section.
6.1.11 Front Cap
The fiberglass front cap does not need any
maintenance except painting as needed. It is
held in place with adhesive. If ever it has to be
replaced, make an appointment at a Prevost
service center near you. For minor damages,
refer to paragraph 4 "Common Fiberglass
Repair procedure" and paragraph 5 "Common
Painting Procedure".
6.2 ZONE 2
FIGURE 18: ZONE 2
6.2.1 Upper Side Panel
For structure preparation, refer to procedure
PR00035 included at the end of this section.
For installation of upper side panel neoprene
foam tapes, refer to procedure
PR00036
included at the end of this section.
For installation of upper side panel, refer to
procedure
PR00041 included at the end of this
section.
6.2.2 Fixed Windows
Depending on the method chosen for fixed side
window removal or installation, you may need:
*
Drill equipped with a sharp pointed rod into
which a small hole was drilled;
* Razor sharp window scraper;
* Braided windshield wire and a pair of
handles;
*
Gloves, goggles or face shield.
Fixed Window Removal
1
st
Method
NOTE
This method is used only in the case of a
regular fixed side window. For the fixed upper
portion of awning or sliding windows, you must
use method number 2.
o
Apply a sticky plastic film onto all of
window outside surface for safety reason.
o
Using a drill equipped with the special
sharp pointed rod, drill through the window
seal into one of the bottom corners, from a
30º angle with reference to the vehicle.
o
This procedure requires accuracy and it is
possible not to succeed on the first at-
tempt. From the inside of vehicle, a sec-
ond person ensures the rod passes
through.
o
Remove the rod; thread the wire into the
small hole. Reinsert the rod and the wire
into the hole far enough so that the person
inside the vehicle can pull the rod using a
pair of pliers.
o
Attach the wire ends to the specially
designed handles.
o
Pull in turn from the inside and the outside
of vehicle to gradually cut the Sika bead
on the window perimeter.
o
When you reach top corner, detach wire
from the outside handle, secure it to a fish
wire or rod and thread it underneath the
aluminum molding behind the rivets.
o
Detach wire from fish wire and continue
cutting using the handle.